Figure 1
(a) Main screen. The input parameters options are displayed on the left panel. A visualization of the Data selection, resulting resistivity and output results are displayed on the right. An example raw data set of Fe at 8 GPa is displayed in Figure 1 [16]. (b) Example of raw data Excel file for Fe at 8 GPa [16] where all measurements are within the first column of the file. The identification of parameter sequence is shown in the right column for the first two sets of data for clarity here only (this not included in the original data file).
Figure 2
(a) Temporary and final selections of the temperature and voltage sections. (b) Calculated resistivity compared with that of Fe at 1 atm [24]. (c) Output values of T (K), ρ (µΩ·cm), error in ρ (µΩ·cm), k (Wm–1K–1) and error in k (Wm–1K–1). (d) Example of the final selections of one measurement for each parameter.
Figure 3
Flowchart summarizing the script architecture. The chart should be read following the blue ribbon.